ATA 23 - Communication Systems Flashcards

1
Q

How many frequencies can you have stored in the VHF control unit?

A

6 ea

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What do the pilots do if the REU (DREU) fails?

A

Switch the NORM/EMER toggle switch to EMER.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

For how long can the PTT X-mit?

A

For a maximum period of 2 minutes. Thereafter is disables automatically.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

What is the frequency spacing in the VHF Control Unit & Transceiver?

A

8.33 KHz

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

What are the HF frequency range?

A

2-29.9999 MHz

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

When shouldn’t the HF transmit?

A

During fuelling or when personnel is close to the A/C.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

At which temperature do the the VHF transceiver automatically shut down? How to override this condition?

A

At 160°. This can be overriden by pushing PTT twice rapidly. This should only be done if needed during an emergency situation.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What happens with the PA system when oil pressure signal is sensed?

A

A boost of 6 dB from the cockpit loudspeakers and the PSU speakers.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

From where is the REU power supplied during the engine start sequence?

A

Both sides of the REU is then powered from the EMERGENCY BUS

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What is the frequency range within the control sub mode (ANC)?

A

80-93.3 hZ

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

When will the inertia switch open and stop the operation of the CVR?

A

When an acceleration greater than 3G occurs.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

When is it possible to erase all data in the solid state flash memory?

(CVR)

A

When aircraft is Weight on Wheels and the gust lock switch is engaged.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

Where is the ANC Test panel installed?

A

Between the Attendants Panel and the hand cradle.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

When will the ANC be active?

A

In flight (WOW and when both the tachometer signals are within the range 80Hz to
93.3Hz

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

Which three components are included in the HF system?

A
  • Transceiver
  • Power Amplifier
  • Antenna Coupler
How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

Where is the PA Amplifier located?

A

In the avionics rack (Bottom RH side)

17
Q

During start up of the system, what does two short 800-Hz tones indicates?

A

That an internal fault in the transceiver unit has been detected.

18
Q

Which signals has a fixed volume?

A
  • Master Warning chime
  • Master Caution chime
  • EGPWS
  • TCAS
  • PA chime signals
19
Q

Which system modes do the PA system have?

A
  • PA
  • CALL
  • EMER
20
Q

What do the EMERG toggle switch on the ACP do?

A

It hotwires the LH/RH headset to COM1 & NAV 1 / COM 2 & NAV 2. Only PTT on the control wheel can now be used.

21
Q
A