Apnea Testing Flashcards
Apnea Testing Order
The apnea test has to be orders by the most responsible health practitioner (ICU attending)
The physician responsible for NDD but be presence of the test and if there is organ donation then two physicians have to be present for the entire duration of the apnea test to determine brain death
How Many RRT should be Present for Apnea Testing
2 RRT and 1 RN must be present for the test
One RRT will perform the apnea test
The other RRT will run, interpret, and report the ABG
When the Test is Run Done What Should be Done
When the test is being run make sure there is no confounding factors that can interfere with spontaneous respiratory efforts such as sedation, toxins, and neuromuscular blockades
If confounding factors are suspected the test should be delayed accordingly or ancillary testing should be considered
Temperature and Apnea Testing
Before the test begins patient core temperature should be greater or equal to 34 degree Celsius
Apnea Testing and Arterial Line
It is optimal to have an arterial line but not a requirement
Apnea Testing and Pre Oxygenation
The patient must be pre-oxygenated on a FiO2 of 100% for at least 5 minutes prior to the apnea test
If the patient is on Heat Humidity
If the patient is on heated humidity, bypass the humidifier and place the HME in line
Ensure the ETCO2 value is stable
Apnea Test confirmation
An apnea test confirmation is defined when ALL of the following clinical criteria have been met
No spontaneous respiration observed
ABG analysis with PaCO2 greater than or equal to 60 mmHg AND greater than or equal to a 20 mmHg PaCO2 change from baseline
pH less than or equal to 7.28
The physician should terminate the apnea test is the following is observed
Visible respiratory efforts
Significant hypotension refractory to vasopressor titration
MAP less then 60 mmHg AND systolic blood pressure less than 90mmHg
Desaturation with SpO2 less then 90% OR PaO2 less than 60 mmHg
What is the very ifrst thing you should so before you start the apnea testing
Veriy order
Ensure all appropriate personnal is there for the procedure
What do you check the patient for before you begin the test
Ensure that patient body temperate is greater than equal to 34 Celsius and hemodynamically stable
SBP greater than or equal to 90 mmHg AND MAP greater than or equal to 60 mmHg
Before disconnecting the patient what should you dicuss with the dr
Prior to removing patient from the vent discuss appropriateness of performing lung recruitment maneuver with doctor
1st ABG you Draw
Will preoxygenate the pt before this
Draw and analyze ABG and adjust ventilator settings to achieve PaCO2 of 35-45 AND pH 7.35-7.45
Repeat ABG until goals are met
Add the comment apnea test in the lab information system
Ensure Perform Time in lab information system is reflective of actually collection time
What do you do after you get the first ABG stabilized
- Connect manual resuscitation to O2 flowmeter and turn flow to 15L/min
- Adjust PEEP valve on resuscitator to same value as the current ventilator setting or 10 cmH2O (whichever is greater)
- Clamp ETT on end inspiration
- This will minimize alveolar derecruitment prior to disconnection from the vent
- Ensure the ETCO2 monitor, HMEF, flex tubing, and closed suction system is in line, disconnect the patient from the vent, and attche manual resuscitator
- Unclamp ETT
- Not eexact time on a single time keeping device used for entire procedure
- Turn off ventilator or put in staby and cap ventilator circuit
- Observe patient chest for any signs of spontaneous respirtory efforts
How often do you draw an ABG
Draw, analyze, and record ABG every 5 min or more often as per the direction of the dr from the time of ventilator was disconnected
Discontinue ABG procurement when PaCO2 has risen greater than or equal to 20 mmHg above baseline AND greater than or equal to 60 mmHg AND pH is less than or equal to 7.28