Aom 2

Question 1

If gate return is necessary, accomplish the following procedure

Answer 1

After land normal procedure and after landing checklist

Question 2

TOTAL RAMP FOB =

ECAM FOB within

Answer 2

+-500#

Question 3

How do you ensure you have enough fuel to pushback?

Answer 3

RQD AT TO + TAXI OUT

Question 4

What is the safety exterior inspection?

Answer 4

Wheel chocks
Landing gear doors
Apu area

Question 5

What is included in the aircraft acceptance procedure?

Answer 5

Aircraft documents
Tail number
Technical condition
Flight paperwork review

Question 6

Battery voltage minimum on preflight check?

Answer 6

25.6, if not then charge for 20 minutes

Question 7

When do you have to perform a battery voltage test?

Answer 7

When aircraft hasn’t been powered for over 6 hours

Question 8

When starting apu you see LOW OIL LEVEL, what are the implications?

Answer 8

You can still start and fly 10 hours before maintenance is needed

Question 9

If you start apu with low oil level message what must you do?

Answer 9

Complete info only write up and advise moc

Question 10

How long must wait after pressing apu master switch on before pressing start?

Answer 10

3 seconds

Question 11

Engine oil quantity for CEO and NEO

Answer 11

V2500
11qts plus .3 qts per hour of flight
P1100g
At or above 14qts
Less than -30c- 16.5 qts

Question 12

When must you accomplish full alignment of the adirs and how long does that take?

Answer 12

First flight of day, change of flight crew, gps not available and poor coverage expected
10 minutes

Question 13

When must you accomplish a quick alignment of the adirs and how do you do it?

Answer 13

If deviation between IRS and fmgc is greater than 5 nm

All knows to off and then back on within 5 seconds

Question 14

Wen do you select low/Econ on the pack flow selector?

Answer 14

A319 less than 138
A320 less than 141
A321 Econ less than 168

Question 15

If center tank less than ______ lbs and you get fuel center tank low pr ecam?

Answer 15

440#

Fuel selector manual and center tank pump 1&2 off

Question 16

Altitude ground tolerance check?

Answer 16

PFD with 25’ of elevation
20’ between the two PFD’s
Isis within 75 of elevation

Question 17

Nd tolerances?

Answer 17

Ground speed less than 5

4 degrees max difference between nds

Question 18

Engine warmup policy?

Answer 18

Shutdown greater than 2 hours - 5 minute warmup

Shutdown less than 2 hours - 3 minute warm up

Question 19

When must you manually abort start on ground?

Answer 19

Tailpipe fire ( com engine tailpipe fire procedure)or electrical interruption(master switch off then dry crank 30 seconds

Question 20

After start ground crew reports leak from engine?

V2500 and pw1100g

Answer 20

V2500 if still present after five minutes then you must contact moc
Pw1100g abort the start

Question 21

When does engine anti ice need to be on?

Answer 21

10 degrees Celsius or below and visible moisture

Question 22

When do you need to perform an engine run up ?

Answer 22

V2500 50% N1 every 15 minutes
Pw1100g Oat -3 c or less and in icing conditions
60% N1 every 30 min. -3–9 colder than -9 every 120 min