Aircraft Inspections Flashcards
What should be done to prevent the rapid deterioration of a tire when oil or grease comes in contact with it?
Wipe the tire with a dry cloth followed by a wash down and rinse with soap and water.
Of the following, which type of inspections can detect subsurface damage?
Magnetic particle inspection, x-ray
The purpose of the developer in the dye penetrant inspection is to:
Draw the penetrant from the fault
Residual magnetism is:
The amount of the magnetism which remains after the magnetizing force is removed.
Circular magnetization is when current is:
Passed through the part being inspected
Longitudinal magnetization is when current is:
Passed through a coil
Which nondestructive testing method is normally the most satisfactory to determine the internal structural condition of a highly stressed cast aluminum alloy fitting?
X-Ray or radiography
Eddy Current inspection can not be used to detect cracks in:
Composite prop blades
Piezoelectric materials can produce:
Electrical potential when pressed, bent or otherwise distorted
Ultrasonic inspection can be carried out by:
A single probe in direct contact with the part being tested.
A transducer placed on both sides of the part being tested.
By immersing the part being tested in a liquid and beaming the energy to the part through the liquid.
To detect a minute crack using dye penetrant inspection usually requires:
A longer-than-normal penetrating time
NDE stand for:
Non-destructive evaluation
Which condition indicates a part has cooled too quickly after being welded?
Cracking adjacent to the weld
An aircraft that is operated under 14CFR Part 135 may exceed the 100-hour inspection interval by:
By 10 hours if necessary to reach a place where the inspection can be accomplished.
The requirements specifying when to inspect the ATC transponder, altimeter and pitot static system will be found in 14CFR Part _____.
91
