Airbus A320 Type Rating Flashcards
MZFW?
61000 kg.
MTOW?
77000 kg.
MLW?
64500 kg.
Maximum FOB?
18728 kg.
APU - How long can the APU be operated after indicating “LOW OIL LEVEL”?
Up to 10 hours.
Vle?
280 kts/ M.67
Vlo extend?
250 kts.
Vlo retract?
220 kts.
Max altitude for gear extension?
25,000 ft.
Max tire speed?
195 kts.
Max brake temp for TO?
300 deg C (and 150 deg C with brake fan on).
Max N1 allowed with Park Brake set?
75%.
Name the 5 Brake Temperature Limitations scenarios where maintenance is required.
“2-15-6-6-9-m”
- same gear brake temp diff > 150 deg C, one brake temp > = 600 deg C.
- same gear brake temp diff > 150 deg C, one brake temp < = 60 deg C.
- left and right gear average temp > = 200 deg C.
- fuse plug melt.
- brake temp > 900 deg C.
What is the max differential cabin pressure?
+8.6 and -1 PSI
What are the restrictions for using HP Ground Unit for air conditioning?
APU bleed should be off. Otherwise may result in bleed system damage.
What are the Pack restrictions for using LP Ground Unit for air conditioning?
Packs should off.
What is the IAS limit for windshield wiper?
230 kts.
When should Engine Anti-Ice be turned on?
Any icing conditions.
Except during climb/cruise when SAT < -40 deg C.
What is the definition of “Icing Conditions” for the engines?
OAT or TAT >= 10 deg C and Visible Moisture.
What speed does SRS maintain?
Takeoff
- 2-engine: V2+10 KT.
- OEI: V2 or current speed, whichever higher limited to V2+15 KT.
Go-Around
- 2-engine: Vapp or current speed, whichever higher limited to V2+25 KT.
- OEI: Vapp or current speed, whichever higher limited to V2+15 KT.
On takeoff, what height is NAV engaged if armed?
30’ RA.
On takeoff, at what height does SRS transit to CLB?
At Acceleration Altitude.
What is Mmo and Vmo?
Mmo = M0.82 Vmo = 350 kts
What is the engine time and EGT limit for takeoff and go-around?
5 mins for takeoff. 10 mins for go-around.
635 deg C for both.
What is the engine time and EGT limit for MCT?
No time limit. 610 deg C.
What is the EGT limit for starting?
635 deg C.
Name the Starter cycles, pause interval between start attempts and cooling period.
3 cycles of 2 min, 2 min and 1 min.
15 sec pause between each cycle.
Cooling period of 30 min after 3 start attempts of 4 min of continuous cranking.
How long must we wait before starting a 2nd set of 3 starter motor duty cycles for the APU?
60 min.