AdjdjdjdjMdjriwpqpGbxjdj

Question 1

Patriot units require a minimum of_______ hours daily of maintenance.

Answer 1

4 Hours

Question 2

How many personnel are required to perform PMCS on the EPP III generators ?

Answer 2

2

Question 3

What is Patriot Prime Power ?

Answer 3

120/208 VAC , 3 Phase , 400 Hertz

Question 4

Park the truck with the EPP III at a suitable location so that it’s distance from the ECS and RS does not exceed the available length of cable on the EPP III drums approximately _________ feet.

Answer 4

75

Question 5

What is the first step in normal shutdown for the 150 Kw EPP III generator ?

Answer 5

Press AC circuit Interrupter OFF

Question 6

Describe the 3 classes of leaks

Answer 6

Class I
A minor leak is indicated by wetness or discoloration, but not enough to form drops.
Class II
A minor leak that is indicated by drops that form, but not enough to drip from the item being inspected.
Class III
A critical leak that is indicated by drops that form and fall from the item being inspected.

Question 7

How are the AMG masts elevated to the vertical position?

Answer 7

Hydraulically

Question 8

What is the approximate maximum height of the AMG masts ?

Answer 8

81 feet

Question 9

What is the max tolerance for level and cross-level for the AMG ?

Answer 9

10 degrees cross roll and 1/2 degree roll

Question 10

What device is used to obtain the AMG vehicle heading ?

Answer 10

Compass

Question 11

When lowering masts , a safety switch automatically stops masts from moving lower than _____ degrees ?

Answer 11

10 degrees

Question 12

How are the AMG masts elevated to the horizontal position ?

Answer 12

Pneumatically

Question 13

How many antenna assemblies are on each of the telescoping masts of the AMG ?

Answer 13

2

Question 14

How long does the AMG crew have to install guy wires ?

Answer 14

Not timed

Question 15

During high winds , AMG mast must be retracted when ?

Answer 15

All the above

Question 16

Where are the AMG controls and indicators for mast warning lights and fault lamps located ?

Answer 16

Distribution Box

Question 17

What Basic gunnery table covers PMCS ?

Answer 17

Table I

Question 18

During extended emplacements some settling may occur. RS roll and cross-roll should be checked every _____ hours. A difference of 2 mils or more may result in radar missile acquisition failure and subsequent missle self- destruct and/or track correlation failure

Answer 18

24 hours

Question 19

What is the radiation hazard distance in front of the radar ?

Answer 19

120m

Question 20

If the RS is to be powered down for more than 2 hours , all shelter doors and air doors MUST be closed

Answer 20

True

Question 21

What is the nomenclature for the SEMITRAILER , FLATBED : RADAR SET ?

Answer 21

M860A1

Question 22

The patriot radar ______ , ________ , and _________ targets ?

Answer 22

Detects , Tracks , Identifies

Question 23

What should the operator do if the kingpin is not secure in the M983 coupler jaws ?

Answer 23

Rock the HEMMT back and forth until the fifth wheel is locked

Question 24

Who is responsible for draining the semitrailer air tank during automatic emplacement of the RS ?

Answer 24

CM 3

Question 25

When leveling the RS at least ______ semitrailer wheel on each side must be off the ground ?

Answer 25

1

Question 26

The Azimuth Drive Local Control (ADLC) is used to position the Radar shelter in the azimuth during the local mode of operation

Answer 26

True

Question 27

How many aiming circles are required to perform manual emplacement on the RS ?

Answer 27

Two aiming circles

Question 28

To prevent equipment damage when raising outriggers , ensure outrigger pads have _______ all the way to the stow position.

Answer 28

Free Movement

Question 29

What encryption device plugs into the Air Defense Interrogator ?

Answer 29

KIV77

Question 30

What power is needed to operate the outriggers of the M860 SEMITRAILER ?

Answer 30

24 VDC

Question 31

What coolant does the AN/MPQ-65 ( Radar Set) use ?

Answer 31

Ethylene Glycol

Question 32

Equipment must be separated by _______ cable distance ?

Answer 32

Maximum

Question 33

What does PDB stand for ?

Answer 33

Post Deployment Build

Question 34

Which alert states require full manning ?

Answer 34

1-4

Question 35

A fire unit has _____ minutes to achieve minimum engagement and ____ minutes to be IAW the STO

Answer 35

Minimum Engagement - 45 min Green Bar ( STO) - 60 min

Question 36

What is an example of active Air Defense Measures ?

Answer 36

Measure taken to destroy enemy aerial objects in flight

Question 37

What is an example of passive Air Defense Measures ?

Answer 37

Cover and concealment , limiting radio frequencies , site hardening.

Question 38

How many alert states are there, and what are they ?

Answer 38

8 alert states 0.IN-TRANSIT(MOVING) 1.ABT 2.TBM 3.PASSIVE SEARCH 4.RADIATE DISABLE 5.COMMANDERS DISCRETION 6.MAINTENANCE 7.NMC/DESTROYED

Question 39

Define all Air Defense Warnings (ADW)

Answer 39

ADW WHITE: ATTACK NOT PROBABLE ADW YELLOW: ATTACK PROBABLE ADW RED: ATTACK IMMINENT or IN PROGRESS

Question 40

Define WCS Hold:

Answer 40

Units may only fire in self-defense or when ordered by proper higher authority

Question 41

Define WCS Tight:

Answer 41

Only targets positively identified as hostile may be engaged

Question 42

Define WCS Free:

Answer 42

Any target not positively identified as friendly may be engaged

Question 43

As part of your March Order drill , you should allow the generator to run at no-load for _____ minutes to cool down the engines

Answer 43

5 mins

Question 44

How long can a generator set run operating on a full load when it has a full fuel tank ?

Answer 44

10 hrs

Question 45

How often should your EPP III generators be load banked ?

Answer 45

Semi-Annually

Question 46

What is the length of the four EPP power cables ?

Answer 46

95 ft

Question 47

In the case of an emergency such as a fuel spill what is the procedure for emergency Shutdown of the EPP III

Answer 47

Remove key from master switch

Question 48

What maintenance form is used for PMCS ?

Answer 48

5988

Question 49

Do not apply power unless voltage switch is set to L1 , wait _____ before applying power.

Answer 49

30 seconds