6.3 Flashcards

1
Q

You arrive on scene to a CO alarm. While inside the building you are exposed to 25 PPM of CO. What type of CO exposure is this/what should you do?

A

CO Emergency.

Other answers were CO Incident, Vacant the building and idk the last one

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

What is an INCORRECT statement about saw operations?

A

During cutting operations, everyone in the vicinity of a saw shall observe as near as possible and practical, a 20’ diameter known as the circle of danger.

Should read 20’ Radius

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

When at a taxpayer fire the responsibility of shutting down gas and electric belongs to who?

A

1st due ladder company inside team

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

Which of the following is NOT a tool that the 1st due irons would bring to the 1st floor of a 2 story taxpayer fire?

A

Hydra-Ram

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

At a taxpayer fire, nothing affects the outcome of an operation as much as _?

A

Ventilation

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

Which statement is true in regards to Maxi-Airbags?

A

A safety relief valves releases air in excess of 118PSI

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

Fast team arrives on the scene and needs to remove a distressed member. FAIR is the acronym that can help assist in the steps for removal. What is INCORRECT in regards to that acronym?

A

Access.

Fire, air, immediate medical care, removal is the right acronym

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

What is a NOT A common method for packaging a member for removal?

A

Use of the Drag Rescue Device (DRD)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What is INCORRECT about two maxi-airbags attached to the same cylinder pressure relief valve?

A

The sum of the tonnage of two bags increases the total weight that can be lifted.

The height is increased, the bottom bag is filled first, they can be used in two different spots in order to increase the surface area

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

When do you NOT use the purge valve on a regulator?

A

Failure of the regulator in the open position, turn counterclockwise

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

What does the irons not bring to the first floor of a two story taxpayer?

A

Hrdra-Ram

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

When do you not inspect the TIC?

A

After MUD (immediately after each tour and after each use is when it is inspected)

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What is the 10 code for a vehicle with its only value to be salvage and with no owner?

A

10-23

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

What is foams ability to resist saturation by hydrocarbons?

A

Fuel Shedding

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

What is correct in regards to proper placement of an apparatus at a car fire?

A

If the apparatus is exposed to possible fire extension, the pump may be placed beyond the fire vehicle. The 2nd apparatus shall always be placed between operating forces and oncoming traffic

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

When performing a single slide your first stop is above the window and out of reach of the victim. True/False.

A

False

During a single slide you are not rescuing a victim

17
Q

When inspecting the PSS at the start of each tour what is NOT included?

A

The figure 8 stopper knot

18
Q

The atlas belt and the personal harness get place out of service after they are subjected to an impact load. What is considered and impact load.

19
Q

What is NOT a use of the aerial ladder?

A

Hold up an unstable wall

20
Q

What is NOT a use of the aerial ladder?

A

Hold up and unstable wall

21
Q

A 12 ton airbag has a max lift of 8.2 inches. How many tons can this bag lift 8.2 inches”

22
Q

T/F When using the TIC low heat spots show up as black images and high heat spots show up as white images.