350-601 VOL3 Flashcards
Which multicasting method uses to advertise group memberships through a routing domain by
constructing multicast distribution trees?
D. Any-Source Multicast
Which Layer 2/Layer 3 protocols increase their hello timers to maintain adjacency during the In-
Service Software Upgrade (ISSU) process? (Choose two).
D. Unidirectional Link Detection (ULD)
E. Bidirectional Forwarding Detection (BFD)
In which of the following scenarios ‘Turn on Locator LED’ action is unavailable during the
renumbering of the Cisco UCS Chassis using Cisco UCS Manager?
B. When the Locator LED is turned on already
Which configuration files can be imported during the backup operation procedure in Cisco UCS
Manager? (Choose two).
C. System configuration
D. Logical configuration
What best practices to consider when managing images to upgrade endpoints in a Cisco UCS
domain? (Choose two).
B. If the /boot flash partition exceeds 70% and 90% capacity, faults are raised
D. Image packages do not have versions
In which circumstances Cisco NX-OS exports a flow as part of a NetFlow export UDP datagram?
A. When you force a flow to export
Using OSPFv3, what happens if the receiving MTU is higher than the IP MTU configured on the
incoming interface?
A. OSPF fails to establish adjacencies
Which of the following is a configuration limitation of BFD features?
D. NX-OS supports IPv4 only
You are a network administrator at a local data center. You are configuring vPC system priority
on LACP to ensure that vPC peer devices are the primary ones on LACP. Which command is used
to configure vPC priorities on LACP?
B. System-priority priority
As a network administrator, you are configuring ACI fabric load balancing. You want to use a load
balancing option for a network where each flow is assigned to an uplink based on a hash of 5-
tuple. The option must provide flow distribution across available links that are roughly even.
Which load balancing option should be used?
C. Static hash load balancing
Which FHRP protocol performs a transparent failover of the first hop gateway router while
providing first hop routing redundancy for IP hosts with a gateway or default route on Ethernet
networks?
D. Hot Standby router protocol
In OSPFv3, Which LSA feature can control and reduce high CPU and buffer usage and allows OSPF
to pack multiple LSAs into an OSPF update message?
C. LSA group pacing
On a Cisco Nexus switch, the TACACS+ feature is disabled is disabled by default. Which of the
following commands must be used to enable this feature?
D. Switch(config)# feature tacacs+
Which of the following security models do Network File Systems (NFS) utilize?
B. Kerberos
Which of the following are true regarding the scalability of VLANs and VXLANs? (Select all that
apply).
B. VLANs support approximately 4000 unique Layer 2 segments.
C. VXLANs support approximately 16 million unique Layer 2 segments.
E. VLANs support approximately 16000 when using QinQ encapsulation
When configuring a Control Plane Policing policy on a Cisco device, which of the following can be
configured as the matching packet types? (Select three)
C. IP Precedence
D. DSCP values
F. Access-group
Which of the following network automation tools uses a push model and does not require an
agent to be installed on the end node?
A. Ansible
Which of the following can be found in the /mnt/pss/ directory of a Cisco MDS 9000 series
switch?
C. Core dump files
You want to make your Cisco MDS 9000 Series switch Federal Information Processing Standards
(FIPS) compliant by using the “fips mode enable” command. Which of the following guidelines
need to be followed prior to doing this? (Select three)
B. Disable telnet
C. Disable SNMP versions 1 and 2.
D. Enable VRRP
