324

Question 1

always check the lathe bed to make sure its

Answer 1

level

Question 2

you should always cut off bar stock for machining

Answer 2

slightly longer than needed

Question 3

longer workpieces should be

Answer 3

mounted between centers

Question 4

when installing a faceplate

Answer 4

screw it on by hand

Question 5

always select a lathe dog

Answer 5

not larger than necessary to accept the workpiece

Question 6

always remember that your depth of cut will

Answer 6

reduce the overall diameter by twice the amount of cut

Question 7

always use a righthand tool when

Answer 7

cutting right to left

Question 8

depending on the hand of cut the cutting tool point should be __ degrees toward the headstock or tailstock

Answer 8

4 to 5

Question 9

in rough turning the cutter point should positioned __ the centerline

Answer 9

5” above

Question 10

with a constant depth cut

Answer 10

an increase in speed requires a decrease in feed

Question 11

when a shoulder is to be turned close to the end of the workpiece use a scale and

Answer 11

hermaphrodite caliper to measure location

Question 12

the bent leg of a hermaphrodite caliper is placed against the ___ of the workpiece

Answer 12

faced end

Question 13

in order to lay off shoulder lengths more accurately when making more than one identical use a

Answer 13

parting tool

Question 14

filleted shoulders are turned with a __ cutting tool

Answer 14

round nosed

Question 15

different size fillets are made by changing

Answer 15

the nose radius on the cutting

Question 16

the split nut assembly is used only when

Answer 16

cutting threads

Question 17

never engage the split nut assembly

Answer 17

when another automatic feed mechanism is in operation

Question 18

the distance from a point on one thread to the same point on the next thread parallel to the screw axis is the

Answer 18

pitch

Question 19

the distance which a point on one thread travels during one revolution of the screw is the

Answer 19

lead

Question 20

when threading long slender workpieces they should always be

Answer 20

supported with a follower or steady rest

Question 21

a 5/8 in.ft taper often used for twist drills reamers end mills and lathe centers is the

Answer 21

morse taper

Question 22

a taper whose calculation depends on its assigned number in the form of a numerator over a constant denominator of 8, 10, or 2 is a

Answer 22

Jarno taper

Question 23

the basic formula for calculating a taper is

Answer 23

Lg dia - small dia / length

Question 24

the taper turning method which requires work to be removed from the lathe for the setup is the ___ method

Answer 24

tailstock setover

Question 25

the amount of inward and outward feed on the lathes compound rest when using the taper attachment is controlled by the

Answer 25

guide bar