2ND 20

Question 1

To prevent a return line in a reservoir from bottoming, it is often cut off at an angle of__________ Degrees.

a) 90
b) 45
c) 60
d) 30

Answer 1

b) 45

Question 2

An adequate reservoir size for a 10 GPM pump would be _______ Gallons.

a) 10
b) 15
c) 30
d) 60

Answer 2

c) 30

Question 3

The plate that prevents the return fluid from recirculating directly back to the inlet is called the ________ .

a) breather
b) mesh
c) baffle
d) mounting

Answer 3

c) baffle

Question 4

The returning fluid to the reservoir is usually _________ than the supply fluid.

a) cooler
b) less
c) cleaner
d) warmer

Answer 4

d) warmer

Question 5

The filler hole in a reservoir is provided with a _______ screen.

a) breather
b) removable
c) micron
d) filter

Answer 5

b) removable

Question 6

Reservoirs are made with connections on top that are set on _________ to keep out contaminants.

a) baffles
b) risers
c) plates
d) fittings

Answer 6

b) risers

Question 7

What is NOT one of the three most common standard reservoir designs?

a) L-shaped
b) overhead stack
c) flat top
d) wedge shaped

Answer 7

d) wedge shaped

Question 8

Fluids with a __________ viscosity index must be kept warm by heaters.

a) high
b) reduced
c) low
d) surface

Answer 8

c) low

Question 9

Reservoir temperature is controlled by _________ .

a) water coolers
b) heaters
c) air coolers
d) all of the above

Answer 9

d) all of the above

Question 10

For reservoir modifications an over-capacity of at least _________ should be provided.

a) 15%
b) 25%
c) 10%
d) 20%

Answer 10

d) 20%