28. Primary Flight Display (PFD) (Indicating/Recording Systems) [O] Flashcards

1
Q

What does each column mean on the PFD?

A

(Col 1) A/THR | (Col 2) VERTICAL | (Col 3) LATERAL |(Col 4) APPCH CAPABILITY, DH/MDA |(Col 5) AP, FD, A/THR ENGAGEMENT STATUS

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
2
Q

How is the crew made aware of mode changes on the FMA?

A

A white box is temporarily displayed around the new indication.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
3
Q

Modes are displayed in the FMA in blue, magenta, and green. What do they indicate?

A

• Blue – armed

• Magenta – armed because of a constraint

• Green – engaged

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
4
Q

When going around in the A320 NEO, if the FMA displays an amber message reading, “FOR GA: SET TOGA”, what action should the pilot take?

A

• The Pilot should move the thrust levers into the TOGA detent.

• When AP/FD is in approach vertical mode and aircraft is below 1000 ft RA, this message is displayed if all thrust levers are moved to or above the MCT detent, but below the TOGA detent

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
5
Q

When is the side stick position indication icon (white cross) displayed?

A

• Displayed when the first engine is started

• Disappears at liftoff

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
6
Q

What do the large red arrowheads indicate?

A

• Pitch attitude of +30°

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
7
Q

After loading an ILS approach into the MCDU and selecting the (I)LS pushbutton, what indications on should be present on the PFD?

A

• ILS frequency and course

• ILS identifier (once in range and identified)

• LOC and GS scales

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
8
Q

When would the sideslip index change from yellow to blue?

A

In case of an engine failure during takeoff/go-around, it becomes a blue beta target.

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
9
Q

What does the yellow speed trend line on the airspeed display indicate?

A

The speed the aircraft will reach in 10 seconds if acceleration/deceleration remains constant

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
10
Q

What is the difference between the magenta and blue target airspeeds?

A

• Magenta – Managed speed computed by the FMGC

• Blue – Selected speed on the FCU

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
11
Q

What is V LS and how is it displayed?

A

• Represents lowest selectable speed providing an appropriate margin to the stall speed

• Defined by the top of the amber strip along the airspeed scale

• In approach mode, it is equivalent to VREF

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
12
Q

What speed does Vmax represent and how is it displayed?

A

• It is the lowest of VMO /VMMO , V LE or VFE

• Defined by the bottom of a red and black strip along the speed scale

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
13
Q

What is Green Dot speed?

A

• Engine out operating speed in clean configuration

• Appears when the aircraft is in the clean configuration

• Corresponds to the best lift-to-drag ratio

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
14
Q

What are the benefits of Ground Speed Mini (GSmini)?

A

• Calculated groundspeed at the runway

• Protects against actual groundspeed dropping below this calculated groundspeed

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
15
Q

What does it mean if the magenta target airspeed triangle is above V APP on the approach?

A

GSmini has increased speed due to a higher headwind component at the present location

How well did you know this?
1
Not at all
2
3
4
5
Perfectly
16
Q

What are the 3 key factors in the GS MINI Calculations?

A

• TWR wind = the MAG WIND entered in the PERF approach page (no gusts)

• TWR headwind component = the component of the MAG WIND projected on the runway axis (landing runway entered in the flight plan).

• Current Headwind Component = the actual wind measured by ADIRS is projected on the aircraft axis to define the current headwind component. The current headwind component is used to compute the variable speed target during final (IAS target).

17
Q

What does it mean when the altitude digits on the altimeter change from green to amber?

A

The aircraft has descended below the MDA/DH entered into the FMGC.

18
Q

When is radio height displayed on the PFD?

A

Below 2,500 feet

19
Q

Information from ILS receiver 1 is displayed where?

A

• Captain’s PFD

• First Officer’s ND

20
Q

What would a flashing amber ILS indicate on the bottom of the PFD?

A

• Flashes amber when APPR mode is armed and the ILS pb is not selected

21
Q

Is a visual warning provided to the pilot if the aircraft is stalling? (NEO v CEO)

A

• Non NEO Aircraft = No visual indication

• NEO Aircraft = STALL warning indication on PFD