Specialized Piping (This is what I failed badly on)

Question 1

What is the minimum clearance around glass pipe passing through sleeves and walls?

Answer 1

50cm, or larger then diameter of pipe.

Question 2

What temp will glass pipe withstand?

Answer 2

300F or 149C

Question 3

What must be done after scoring the Glass pipe with the cutter before snapping it apart?

Answer 3

Apply heat to the scored mark

Question 4

What is the maximum degree of deflection for a glass pipe coupling?

Answer 4

4 Degrees

Question 5

Is fiberglass pipe thermosetting or thermoplastic pipe?

Answer 5

Thermosetting

Question 6

Two uses for Fiberglass pipe?

Answer 6

Chemical Prossing/Food Processing

Question 7

Air system piping, how often should a drip leg be installed?

Answer 7

Every 50 to 100 Feet in the distribution system

Question 8

Water can accumulate in the tank and air lines, to the point where it could fill up the control and leak out of the control ports?

Answer 8

Yes

Question 9

To minimize oil pumping, a compressor tank should hold 33% of the required hourly air?

Answer 9

Yes

Question 10

Properly sized duplex air compressors will reduce overall operating temperatures?

Answer 10

Yes

Question 11

should you ever install a shut-off valve between a compressor and receiver if no a relief valve is installed between?

Answer 11

No

Question 12

What grade should be applied to all compressed air piping?

Answer 12

1:200

Question 13

What direction is the grade applied for compressed air piping?

Answer 13

Direction of flow