Saturation UK REG questions Flashcards
- Buoyant Bell should have your buoyancy checked ?
a) every 3 months
b) every 6 months
c) every year
d) every 5 years
c) every year
- Buoyant bells should have their buoyancy checked by substituting what weight per diver ?
a) 100kg
b) 80 kg
c) 90 kg
d) 150kg
d) 150kg
- On gas reclaim system, the bell divers gas supply should have on-line in Dive control ?
a) hi/lo O2 & Co2 analyzers
b) hi/lo o2 analyser, low Co2
c) hi/lo o2 analyzer, high Co2
d) high o2 analyzer, high Co2
c) hi/lo o2 analyzer, high Co2
- Bell life support equipment ought to have a minimum duration of?
a) 12h
b) 24h
c) 48h
d) 72h
b) 24h
- A bell O2 adds system should be fitted to?
a) all close bells
b) all wet/ open bells
c) every diving system exposed to greater than 100mb internal pressure
d) all bells used below 50 mq
a) all close bells
- Secondary bell comms must be by?
a) emergency telephone
b) through water comms
c) flashing lights
d) umbilical line pull signals
a) emergency telephone
- How often must diving bells in U.K. be tested at greater than mwp?
a) 5 yearly
b) 2 yearly
c) yearly
d) 3 yearly
a) 5 yearly
- How often must gas cylinders on the outside of the hyperbaric rescue vessel be leak tested to mwp?
a) yearly
b) 2 yearly
c) 5 yearly
d) 10 yearly
b) 2 yearly
- A bell diver is working when a red alert occurs. Would you?
a) bring the diver into the bell then bring the bell up
b) bring the diver to clump weight
c) consult captain as to where the diver should go
d) bring diver to outside of the jacket
a) bring into the bell then bring the bell up
- When should the door of the TUP to the bell trunk be closed?
a) when divers are showering
b) when divers have transferred
c) when decompressing
d) all of the above
d) all of the above
- What is the minimum diving team for the closed bell ops?
a) 5
b) 7
c) 9
d) 12
d) 9
Note: you may be asked their job titles
➢ Diving supervisor ➢ Two life support supervisors ➢ Two life support technicians ➢ Two divers in the bell ➢ Standby diver on the surface ➢ Tender for the standby diver
- What’s the recommended maximum time in saturation ?
a) 30 days including deco
b) 28 days including deco
c) 30 days excluding deco
d) 28 days excluding deco
b) 28 days including deco
- What’s the maximum bell run seal to seal?
a) 7h
b) 8h
c) 10h
d) not specified
b) 8h
- What’s the minimum rest periods of bell divers after the bell run?
a) 6h
b) 8h
c) 12h
d) 16h
c) 12h
- When operating a 3 man bell run, what’s the maximum lock out time for each diver?
a) 4h
b) 6h
c) 8h
d) any with their agreement
b) 6h
- How may it be necessary to test hyperbaric lifeboat internal gas cylinder above mwp?
a) 1 year
b) 2 years
c) 5 years
d) 10 years
b) 2 years
- After a Heliox saturation diving, a diver (with no DCI) should not fly internationally for at least ?
a) 12h
b) 24h
c) 48h
d) 6h
b) 24h
- When could the TUPC to bell trunk door be left open?
a) when living chamber to door is closed
b) when the diver is working in the bell
c) during the pre dive checks
d) only when the diver is going through to the bell
d) only when the diver is going through to the bell
- Under a normal circumstances after an 18 days sat, how long should a diver remain at atmospheric pressure?
a) 28 days
b) 9 days
c) 18 days
d) 6h
b) 9 days
Note
i) The surface interval should not be less than 50% of the duration of the preceding saturation dive or 10 days whichever is the lesser.
ii) Where a diver carries out two saturation dives separated by a shorter surface interval than that defined in 2.1, the surface interval subsequent to the two dives should be not less than
the duration of the longer of the two saturations.
A diver’s cumulative saturation exposure should not exceed 182 days in any 12 calendar months.
- On a 24h round the clock sat diving ops, how many bell supv would be required ?
a) 2
b) 2+1 supt
c) 4
d) 2+1 lss
c) 4
- During a 3 man bell runs where divers spend more than 4h in the water, they should?
a) be offered refreshments breaks after 2h lockout
b) spend every 3rd dive dry as the bell man
c) only lockout in pairs
d) both a & b
d) both a & b
- How many life support personnel must be at or the vicinity of the life support control point?
a) 1
b) 2
c) 1+1 getting lunches
d) 1+1 lss on call
b) 2
- What type of bell would have its beacon set on channel B and would the reply frequency would be?
a) an observation bell, frequency of 37.5 kHz
b) a DSV Bell, frequency of 38.5 kHz
c) a DSV Bell, frequency of 39.5 kHz
d) a rescue bell, frequency of 37.5 kHz
D
PS: the question is asking about rescue channels. Could be channel A or B.
- What’s the reply frequency and interrogation frequency on a channel A beacon?
a) reply 37.5 kHz, interrogation 38.5 kHz
b) reply 38.5 kHz, interrogation 39.5 kHz
c) reply 39.5 kHz, interrogation 39.5 kHz
d) reply 37.5 kHz, interrogation 37.5 kHz
a) reply 37.5 kHz, interrogation 38.5 kHz
- Who must the A supervisor be able to see during an enclosed bell ops?
a) the winch driver
b) the divers in the bell and the chamber
c) the life support control station
d) the surface standby diver
e) all of the above
b) the divers in the bell and the chamber
- When new gas arrives on board you?
Analyse them
- HLB minimum life support period?
72 hours
- Pre dive sat medicals should be carried out within what time, prior diving?
24 hours
- How long is a divers “fitness to dive medical “ valid for?
12 months
- According to IMCA How many supervisors can be appointed to supervise at any one time?
2 supervisors
Supervisor in charge is the one signing the logbook
The other is identified as a second supervisor.
Note: IMCA D014. (3.4 section)
- Who can appoint a diving supervisor?
DIVING CONTRACTOR
2% O2 must always be a helium used in diving ops. What’s the minimum required for N2?
a) 100n2
b) 10% O2
c) 2%N2
d) 5%O2
C) 2%
An HRV must meet certain criteria listed below:
a. Green in colour and clearly marked with two visible signs
b. Orange in colour and clearly marked with two visible signs
c. Orange in colour and clearly marked with three visible signs
d. Red in colour and clearly marked with three visible signs
c. Orange in colour and clearly marked with three visible signs
When using a cross-haul wire on a bell, the wire must be?
a) 1.5 x swl of main wire
b) sufficient strength to lift bell to interface
c) 8:1 safety factor
d) 6.5 x swl of main wire
c) 8:1 safety factor
What’s the recommended minimum breaking strain of a bell winch wire?
a) 1.5 x the working load
b) 1.25 x the working load
c) 1.1 x the working load
d) 8 x the working load
d) 8 x the working load
Main bell wire should be rated above SWL by a factor of:
a. 1.25:1
b. 1.3:1
c. 3:1
d. 8:1
d. 8:1