chapter 4

Question 1

When you set Object Snap options in drafting settings dialog box, the object snaps are:
A- tracking points for object snap tracking
B- overrides to preset object snaps
C- the same as the object snaps in the shortcut menu
D- available when you need to pick a point

Answer 1

A- available when you need to pick a point

Question 2

What type of objects does the Center object snap work with?
A- circles and lines
B- circles, arcs, and rectangles
C-circles, arcs, and lines
D- circles and arcs

Answer 2

D- Circles and arcs

Question 3

Which Object snap enables you to position an object at the center of a rectangle what was created using the rectang command?
A- Center object snap
B- geometric Center object snap
C- Midpoint object snap
D-Intersection Object Snap

Answer 3

B- geometric Center object snap

Question 4

When can you use an object snap override from the shortcut menu?
A- when snap mode is toggled on in the status bar
B- when object snap mode is toggled on in the status bar
C- after you start a command and the software prompts you for a point
D- any time

Answer 4

C- after you start a command and the software prompts you for a point

Question 5

If you set the polar tracking increment angles to 18,36,54,… you can track to the multiples of 18° in addition to horizontal and vertical lines.
A- true
B- False

Answer 5

A- True

Question 6

which settings in the status bar should be toggled on to use the object snap tracking?
A- object snap tracking and polar tracking
B- object snap tracking and object snap
C- object snap tracking and snap mode
D- Only object snap tracking

Answer 6

B- object snap tracking and object snap

Question 7

what happens when you type snap in the command line, select legacy, and then select yes to toggle it on?
A-it forces the cursor to always snap to the snap grid, even if you are not in an active command
B- it displays the grid as a series of dots rather than lines
C- the snap increments are measured along the polar tracking lines and works when polar tracking is on
D-the grid and the cursor become angled and it makes it easier to draw a 2d isometric part

Answer 7

A-it forces the cursor to always snap to the snap grid, even if you are not in an active command

Question 8

when using isometric drafting, which of the following isoplanes are available in the isometric drawing environment?
A- Isoplane right
B- Isoplane left
C- Isoplane front
D- Isoplane top
E- Isoplane bottom

Answer 8

A- Isoplane right
B- Isoplane left
D- Isoplane top